How To Apply

Step-by-Step Instructions

- Wash the application area with soap and water.

- Dry thoroughly with a lint-free towel.

- With the backing still on, place the sticker on the surface where you want it.

- Measure and adjust until it’s straight and centered.

- Lift the sticker using the tape hinge.

- Slowly peel away the backing paper, exposing the adhesive side.

- While holding the sticker above the surface (without letting it touch yet), align and begin pressing it down from top to bottom.

- Use a squeegee or credit card to press the sticker onto the surface.

- Start in the center and move outward to push out air bubbles.

- Slowly peel the transfer tape back at a 45° angle.

- If any part of the decal lifts, press it back down with your squeegee.

- Check for small bubbles. Poke them with a pin and press flat.

- Avoid washing the vehicle or getting the area wet for 24 hours.

- Apply in a shaded area between 50°F and 90°F (10°C to 32°C).

- Don’t rush — patience helps avoid bubbles and misalignment.

- For long-lasting results, don’t apply to freshly waxed or dirty surfaces.